配置设备对接NLB 服务器群集示例（通过多端口ARP

胡振宇

在Switch上创建VLAN，并将接口加入到VLAN中。
<HUAWEI> system-view
[HUAWEI] sysname Switch
[Switch] interface gigabitethernet 1/0/1
[Switch-GigabitEthernet1/0/1] port link-type access
[Switch-GigabitEthernet1/0/1] quit
[Switch] interface gigabitethernet 1/0/2
[Switch-GigabitEthernet1/0/2] port link-type access
[Switch-GigabitEthernet1/0/2] quit
[Switch] interface gigabitethernet 1/0/3
[Switch-GigabitEthernet1/0/3] port link-type access
[Switch-GigabitEthernet1/0/3] quit
[Switch] vlan 10
[Switch-vlan10] port gigabitethernet 1/0/1 to 1/0/3
[Switch-vlan10] quit
步骤2 在Switch上创建VLANIF接口，并配置IP地址
[Switch] interface vlanif 10
[Switch-Vlanif10] ip address 10.128.246.251 24
[Switch-Vlanif10] quit
步骤3 在Switch上配置对应多出接口的MAC地址表项
[Switch] mac-address multiport 03bf-0a80-f6fc interface gigabitethernet 1/0/1 to gigabitethernet
1/0/3 vlan 10 //配置对应多出接口的MAC地址表项
步骤4 在Switch上配置静态ARP表项
[Switch] arp static 10.128.246.252 03bf-0a80-f6fc //此处必须配置短静态ARP表项
[Switch] quit
步骤